With this pedal crank axle kit the span between the pedals is 13 inches.
(DOES NOT INCLUDE CRANK ARMS)
This axle is raw unfinished 1018 steel, paint it or clear coat to prevent rusting.
Made in USA.
This crankset can be the base of a do it yourself
reduction drive or CVT pedal shaft.
Crank arms can be reclaimed from a discarded bike
as the square tapper arms are very common.
Cut off the spider of the crank arms, with an angle grinder.
INCLUDES ITEMS PICTURED:
2 snap rings, 2 8mm Fine bolts for attaching crank arms
American Sealed Bottom Bracket Set 3/4 I.D.
Fits standard 2 inch diameter bottom bracket shell.
3/4″inch I.D. Standard Pedal Sprocket Holder
this sprocket holder was designed so you can use a standard
1 piece crank sprocket.
You just need to drill 3 holes in your sprocket.
Includes: 4 Allen head bolts and 3/16th keystock.
Axle Total Length: 12 inches
Standard Squarer Tapper Ends (DOES NOT INCLUDE CRANK ARMS)
Designed for the 2 inch diameter, 68mm wide, beach cruiser
American 1 piece bottom bracket with 3/4inch bore.
Pedal Axle Total Length: 12 inches
Material: 1018 Case hardened steel.
Good weld-able qualities. Made In USA
Diameter: 3/4 of an inch
Ends Standard Square Taper with 8mm FINE tapped hole in center.
Snap Ring Slots at 4 1/4, 4 1/2inches, and 7 1/2inches
Keyway uses 3/16th stock
Weight: 1Lb 5.4oz
The Axle was designed with a pull start
of engine offset to the right.
New snap ring slots can be filed,
dremeled or lathed out and
left to right adjustments can be made.
Please see samples in the Bike Gallery
Out of stock